Description | Example | Return Message | Group

RdrAdvModel

Set properties for the radar advanced environment (Deprecated Command)

Syntax

RdrAdvModel <RdrObjectPath> {ModelOption} [<Parameters>]

ATTENTION: THIS COMMAND IS DEPRECATED and has been replaced by:

Description

This command was deprecated in STK 10.1, it should no longer be used. This command has been replaced by the Radar command.

The RdrAdvModel Connect command allows you to define the advanced environment properties for the specified radar. {ModelOption} and <Parameters> can be:

{ModelOption}	<Parameters>
Enable	N/A
Disable	N/A
PulseCompRatio	<Value>
BandWidth	<Value> in frequency units
NumDetections	<Value>
FalseAlarm	<Value>
WaveForm	{Action} [<DeltaRF> <prf> <NumPulses>] {Action} can be Add, Delete or Clear. <DeltaRF> and <prf> are entered in frequency units. Clear removes all but the first WaveForm.

If the {ModelOption} is WaveForm, you must specify between 1 and 5 waveforms. If you try to remove the last WaveForm or add a sixth WaveForm, Connect will return a NACK.

Example

To add a waveform with a DeltaRF of 1, prf of 0.00002 and NumPulses 22:

RdrAdvModel */Facility/Customer/Radar/TestRadar WaveForm Add 1 0.00002 22

To add a waveform with a DeltaRF of 0.3, prf of 0.00003 and NumPulses 23:

RdrAdvModel */Facility/Customer/Radar/TestRadar WaveForm Add 0.3 0.00003 23

ReturnMessage

Group Membership

This command belongs to the following group(s):

Radar

Deprecated Commands

Version

10.1