MaxTurnRadiusFactor
Specify the maximum turn radius factor for the procedure.
Related Commands
- MissionModeler Procedure (ArcEnroute) SetValue
- MissionModeler Procedure (Basic Point to Point) SetValue
- MissionModeler Procedure (Enroute) SetValue
- MissionModeler Procedure (Landing) SetValue
- MissionModeler Procedure (Holding - Racetrack) SetValue
- MissionModeler Procedure (Holding - Circular) SetValue
- MissionModeler Procedure (Holding - Figure-8) SetValue
- MissionModeler Procedure (Landing) SetValue
- MissionModeler Procedure (Terrain Following) SetValue
- MissionModeler Procedure (Transition to Hover) SetValue
Syntax
MissionModeler <AircraftObjPath> Procedure <Index> SetValue MaxTurnRadiusFactor <Value>
Description
The MaxTurnRadiusFactor is the maximum amount - expressed as a multiplier - that the turn radius will be increased to minimize the bank angle required to complete the turn.
<Index> | Enter the index of the procedure being modified. This attribute is valid for ArcEnroute, Basic Point to Point, Enroute, Holding, Landing, Terrain Following and Transition to Hover procedures. |
<Value> | Enter a real value greater or equal to 1. |
Examples
MissionModeler */Aircraft/Aircraft1 Procedure 1 SetValue MaxTurnRadiusFactor 2.0