Set access to use the whole object during computations.
SetAccessOption <ObjectPath> {Whole | Any}
If Whole is selected, then access to the object is constrained to when it is established to the entire object. When Any is selected, then access can be established to any part of the object.
The SetAccessOption command is valid for Area Targets and Line Targets only.
To set LT1 to use the whole line target when establishing access:
SetAccessOption */LineTarget/LT1 Whole
To set access for the Penna Area Target to use any part of the object:
SetAccessOption */AreaTarget/Penna Any
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
6.2
STK Programming Interface 11.0.1