Save or check in a VDF or STK object to the ADF (Deprecated Command)
ADFSave <ApplicationPath> <ObjectPath> "<ServerFilePath>" [<Options>]
Note: This command was deprecated in STK 10, it should no longer be used. This command has been replaced by the SDFSave command.
The ADFSave connect command allows a user to save or check-in a VDF or STK object as a file on the AGI Data Federate (ADF) server.
The <ObjectPath> specifies the object being saved. The "<ServerFilePath>" specifies the file path on the ADF server.
The following table describes the optional parameters.
| <Options> | Description |
|---|---|
| EnableRevControl | Enter this option to configure the file for versioning. If not entered the file will be saved normally. |
| RevisionComments "<Comments>" | Enter information about the changes that you have made to the file. |
| PackageOverview "<Overview>" | Enter overview information about the file. If not specified any previous overview will be retained |
To check the BasicSTK VDF into the ADF:
ADFSave / * "Users/stkUser" EnableRevControl RevisionComments "This is the initial submission." PackageOverview "This is my BasicSTK scenario."
To check-in the SOPHIA aircraft to the ADF:
ADFSave / */Aircraft/SOPHIA "Users/stkUser" EnableRevControl RevisionComments "This is the initial submission." PackageOverview "This is my SOPHIA aircraft file."
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
10
STK Programming Interface 11.0.1