SetConnectReportUnitsFlag

Turn on or off the use of Connect report units. (Deprecated Command)

Syntax

SetConnectReportUnitsFlag <ScenarioPath> {On | Off}

ATTENTION: THIS COMMAND IS DEPRECATED and has been replaced by:

Description

Note: This command was deprecated in STK 10.1, it should no longer be used. This command has been replaced by the Units_Set command.

The SetConnectReportUnitsFlag command is used to turn on or off the use of Connect report units. When On reports and graphs generated via connect will use the units set by the SetConnectReportUnits command.

Example

To turn on the use of Connect report units for subsequent reports created via Connect:

SetConnectReportUnitsFlag * On

ReturnMessage

If activated, Connect returns an acknowledgement message.

Group Membership

This command belongs to the following group(s):

Scenarios

Deprecated Commands

Version

10.1

STK Programming Interface 11.0.1