SetReportUnits

Set units of measure to be used when generating and displaying reports during the current Connect session (Deprecated Command)

Syntax

SetReportUnits <ScenarioPath> {Dimension} <Unit> ["<Offset>"] [{Dimension2} {Unit2}...]

ATTENTION: THIS COMMAND IS DEPRECATED and has been replaced by:

Description

Note: This command was deprecated in STK 10.1, it should no longer be used. This command has been replaced by the Units_Set command.

The SetReportUnits Connect command allows you to set the units of measure for all reports generated. The units of measure available are identical to the units for the SetGUIUnits command.

Hint: Connect recognizes a number of <Unit> abbreviations. Use the abbreviated commands or alternative forms to set units. You can also change the units used to relay commands using the SetUnits command or the units used to input data via the user interface using the SetGUIUnits command.

Warning: The SetReportUnits command alters the display of all reports generated during a Connect session.

Example

To set the time units to display in hours, the distance units to display in kilometers, the bandwidth to display in gigahertz, and the ratio to display in decibels:

SetReportUnits * TIME HOUR DISTANCE KM BANDWIDTH GHZ RATIO DECIBEL

ReturnMessage

If activated, Connect returns an acknowledgement message.

Group Membership

This command belongs to the following group(s):

Scenarios

Deprecated Commands

Version

10.1

STK Programming Interface 11.0.1