Control the projection of a sensor in the 3D window
VO <ObjectPath> Projection {ProjectionOption}
The VO Projection command enables you to control the projection of a sensor's cone in 3D space.
| {ProjectionOption} | Description |
|---|---|
| Intersection {All | None | Earth} | All displays the entire sensor projection. Earth displays only the portion of the sensor projection that intersects the Earth. None causes no projection to display. |
| TargetDistance <Value> | If the Pointing type for the sensor is set to Targeted, specifies the targeting distance, or how far past the target a sensor is projected (typically, this field is set to zero). |
| SpaceProjection <Value> | Specifies the length of the sensor's projection when it is not intersecting the Earth. |
| UseExtensionDistance {On | Off} | If set to on, the maximum distance drawn along the sensor boundary is scaled to the targeting extension distance for targeting sensors or the space projection extension distance for non-targeting sensors. |
| UseRangeConstraint {On | Off} | If set to on, sensor graphics display a dome-shaped cap on the end of the sensor projection. |
| Inherit2DDistance {Yes | Extent | No} | Indicates how projection distances that
are computed based on 2D Graphics projection settings are displayed
in the 3D Graphics window.
|
To display only the portion of the Downlink's projection that intersects with the Earth:
VO */Satellite/ERS1/Sensor/Downlink Projection Intersection Earth
To display the Downlink's projection out to 30,000,000,000 m into space:
VO */Satellite/ERS1/Sensor/Downlink Projection SpaceProjection 30000000000.0
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
7.1
STK Programming Interface 11.0.1