Save or check in a VDF or STK object to the STK Data Federate (SDF) servers.
SDFSave <ApplicationPath> <ObjectPath> "<ServerFilePath>" [<Options>]
The SDFSave connect command allows a user to save or check-in a VDF or STK object as a file on the STK Data Federate (SDF) server.
The <ObjectPath> specifies the object being saved. The "<ServerFilePath>" specifies the file path on the SDF server.
The following table describes the optional parameters.
| <Options> | Description |
|---|---|
| RevisionComments "<Comments>" | Enter information about the changes that you have made to the file. |
| PackageOverview "<Overview>" | Enter overview information about the file. If not specified any previous overview will be retained. |
| ServerName <ServerName> | Include ServerName <ServerName> to save to a specific server. This option is required if more than one server is available. |
| EnableRevControl | Enter this option to configure the file
for versioning. If not entered the file will be saved normally.
This option has been deprecated. As of SDF v2.0 revision control will always be on. Entering this option will no longer have any effect. |
To check the BasicSTK VDF into the SDF:
SDFSave / * "Users/stkUser" ServerName "Test1" RevisionComments "This is the initial submission." PackageOverview "This is my BasicSTK scenario."
To check-in the SOPHIA aircraft to the SDF:
SDFSave / */Aircraft/SOPHIA "Users/stkUser" RevisionComments "This is the initial submission." PackageOverview "This is my SOPHIA aircraft file."
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
11.2
STK 11.2.1 Programming Interface