TE_Vector
Generate a vector for T&E.
Syntax
TE_Vector <ObjectPath> Add Name "<Name>" AnalysisObject "<Name>" Mapping "<Name>" PointPath "<Name>" <Parameters>
Related Commands
Description
The T&E Toolkit (v1.5) Plugin must be installed in order to use this command.
The TE_Vector command is used to create a vector using the vector mapping and attachment point specified.
Name "<Name>" specifies the name of the vector. This parameter is required.
AnalysisObject "<Name>" is the name of the analysis object. This parameter is required.
Mapping "<Name>" is the name of the vector mapping. This parameter is required.
PointPath "<Name>" is the name of the attachment point. This parameter is required.
The following table describes other parameters.
| <Parameters> | Description |
|---|---|
| Color "<Color>" | Enter a color for the vector. The default color is white.
Color may be entered using name, value or %rgb. |
| ShowLabel "{On | Off}" | The default value is Off. |
| ShowValue "{On | Off}" | The default value is Off. |
| Size "<Number>" | Specify the size of the vector, valid values are between 1 and 100.
This vector size will be used for all vectors in the scenario. |
| IntervalPath "<Point>" | Enter name of time interval vector. |
| Gradient "<DataElement>,<Value1>,<Color1>,<Value2>,<Color2>,..." | Enter the data element, followed by a comma separated list of value, color. See below for format of <DataElement>. |
| BelowColor "<Color>" | Enter a color. This parameter is optional. By defining this parameter, an additional level is added that is less than the lowest defined <Value> parameter. |
| Above "{On | Off}" | Set the above parameter on or off. This parameter is optional. Setting this parameter to "On" will set the highest defined <Value> parameter as any value above the next highest defined <Value> parameter. This does not add a new level like the BelowColor parameter. |
The format for specifying <DataElement> is: "[<SourceName> |] <ShortName>". If the <ShortName> is enough to identify the element then just enter that. Otherwise, include the <SourceName> followed by the | (bar), before the <ShortName>. Refer to examples of each below.
Example
TE_Vector * Add Name "Vector1" AnalysisObejct "AF385" Mapping "OwnshipVector" PointPath "Center" ShowLabel "ON" ShowValue "ON" Color "orange" Size "5.0" IntervalPath "Radar_Run1"
ReturnMessage
Group Membership
This command belongs to the following group(s):
You can use TETK Connect commands in TETK scenarios for pre-flight planning, post-flight analysis, and to support analysis workflows.
You should not use TETK Connect commands when real-time propagators are creating STK vehicles and using STK features instantaneously. The use of Connect commands in a real-time application requires more computational power than STK can support.
TETK functionality that is commonly referred to as "real-time" is actually an offline analysis mode. In this mode, an STK/TETK scenario is prepared with data that is streamed to a particular time in a mission. The post-flight analysis can be prepared again on demand throughout the mission for the data for each time of request. You can use TETK Connect commands in these scenarios.
Version
11.6