PropagatedRoute Properties |
The PropagatedRoute type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | CentralBody |
Gets the central body on which this route is defined.
|
| ConnectionConfigurationResults |
Gets a list containing results for the connections where there was a problem or other metadata associated with configuration.
This can often occur if the geometry of the surrounding procedures makes the geometry of a connection infeasible or
if the geometry violates user specified constraints in order to connect. To avoid these cases, try allowing the
surrounding procedures to adjust their heights and speeds to accommodate for the constraints on the connection.
|
| HasConfigurationErrors |
Gets a value indicating whether there were errors while configuring the route.
If the configuration was not successful, information about where the error occurs and why
can be found in the ProcedureConfigurationResults. Errors can mean
that there are discontinuities in the route (in cases where the system was unable to
find any valid trajectory) or simply represent errors where the intended behavior was
infeasible due to over-defined constraints (but still may have produced a smooth route).
|
| IsFrozen |
Gets a value indicating whether this object is frozen. A frozen object cannot be modified and an
ObjectFrozenException will be thrown if an attempt is made to do so.
(Inherited from DefinitionalObject.) |
| OverallSurfaceDistance |
Gets the overall distance along the projection of the route onto the Ellipsoid
shape of the CentralBody.
|
| ProcedureConfigurationResults |
Gets a list containing results for procedures where there was a problem or other metadata associated with the configuration.
This can often occur if the geometry of surrounding procedures is infeasible or if some dynamical constraint
is violated in the process of propagating a particular procedure.
|
| Segments |
Gets the list of parametric segments defining the geometry of the individual pieces of the route,
which together form the overall trajectory. In general, these segments are only needed for diagnostic
purposes. The position can be obtained by using CreatePointFromRoute. The surface
geometry can be obtained by using CreateSurfaceCurve. Lastly, scalars are available
to interpolate Heading, Height,
Surface Speed, and Total Speed.
So, these segments should only be used if information regarding the geometry at a specific procedure is required.
|
| Start |
Gets the start date of the route.
|
| Stop |
Gets the stop date at the end of the route.
|
See Also