Ellipsoid Properties

The Ellipsoid type exposes the following members.

Properties

	Name	Description
	CenterTolerance	Gets the numerical tolerance used to determine if a point is located near the center of the ellipsoid. The value is expressed as a percentage with respect to the unit sphere representing the scaled ellipsoid. By default, the value is approximately 30%.
	EllipsoidType	Gets the type of the ellipsoid based on the semiaxis lengths.
	SemiaxisLengths	Gets the semiaxis lengths.
	SemimajorAxisLength	Gets the largest semiaxis length.
	SemiminorAxisLength	Gets the smallest semiaxis length.
	SurfaceTolerance	Gets the numerical tolerance used to determine if a point is located on the surface of the ellipsoid.
	Volume	Gets the volume of the ellipsoid.