Graphics ContourSet
Control the antenna pattern resolution for contouring.
Syntax
Graphics <CommObjectPath> ContourSet {ContourOption} <Parameters>
Related commands
Description
Use the Graphics ContourSet command to set the antenna pattern resolution for contouring. The finer the resolution, the smoother the graphics appear. The following table describes the {ContourOption} <Parameters>.
{ContourOption} <Parameters> | Description |
---|---|
ShowGfx {On | Off} | Turn on or off the contour graphics. |
ShowAtAlt {On <Altitude> | Off} | Show the contour at the specified altitude above the Earth. <Altitude> is entered in Connect distance units, and must be greater or equal to -1000.0 meters. |
"{ContourType}" <Params> | Set the antenna pattern resolution based on the contour type. Valid values for {ContourType} are: "Antenna Gain", "Flux Density", "Spectral Flux Density", "EIRP", "RIP". See the following table for a description of <Params> for the {ContourType}. |
The following table describes the <Params> based on {ContourType}. For Receivers and Antennas the only valid value for {ContourType} is "Antenna Gain".
{ContourType} | <Params> | Description |
---|---|---|
"Antenna Gain" | Pattern <NumAz> <azStart> <azStop> <NumEl> <elStart> <elStop>
Pattern <AzResolution> <ElResolution> <MaxEl> | <NumAz> and <NumEl> must be between 2 and 1000. <azStart>, <azStop>, <elStart> and <elStop> must be between -180.0 and 180 degrees.
<AzResolution> and <ElResolution> must be between 0.000001 and 30. <MaxEl> is entered in degrees and must be between 0 and 90.0. |
"EIRP" | ||
"Flux Density" | LatLon <AzResolution> <ElResolution> <MaxEl> | <AzResolution> and <ElResolution> must be between 0.000001 and 30. <MaxEl> is entered in degrees and must be between 0 and 90.0. |
"Spectral Flux Density" | ||
"RIP" |
Receiver and transmitter graphics can be displayed only if the transmitter or receiver is defined as a Complex, GPS Satellite, Laser, or Multibeam model. Because the Simple and Medium antenna models are isotropic, there is no data to contour.
Examples
Return message
Group membership
This command belongs to the following group(s):
Version
11.4