Description | Example | Return message | Group

SetConstraint (SEET)

Set a SEET constraint for a vehicle

Syntax

SetConstraint <ObjectPath> {ConstraintName} <Parameters>

Related commands

Description

Caution should be exercised when turning a constraint Off, in that any previously set constraint values may be lost. These cannot be recovered when the constraint is subsequently turned On.

You can use the SetConstraint command to turn SEET constraints On and Off and also set values for the constraints. The following table lists valid values for {ConstraintName} as well as the parameters accepted for each. Only one constraint can be set with each SetConstraint command.

SEET Constraints

The following constraints are valid for Satellite, Launch Vehicle, and Missile objects:

{ConstraintName}Parameters
SEETSAAFluxIntensity{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in m^2*sec*steradian and are between 0.5*1.0e4 and 10000.0*1.0e4.
SEETDamageFlux{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0.
SEETDamageMassFlux{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0.
SEETImpactFlux{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0.
SEETImpactMassFlux{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0.
SEETVehicleTemperature{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in degrees Kelvin and are between 0.0 and 5770.
SEETMagFieldLineSeparation{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in degrees and are between 0.0 and 180.0.
SEETMagFieldLshell{Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are between 1.0 and 100.0.

Examples

To set minimum and maximum values for the SEETDamageFlux constraint:

SetConstraint */Satellite/Satellite1 SEETDamageFlux Min 0.0000001 Max 0.001

Return message

Group membership

This command belongs to the following group(s):

Vehicles

Version

9.1