Comm CommSystem Interference

Control the calculation of interference (Deprecated Command)

Syntax

Comm <CommSysObjectPath> CommSystem Interference {Yes | No} [{PFDRefBandwidth}]

ATTENTION: THIS COMMAND IS DEPRECATED and has been replaced by:

Description

Note: This command was deprecated in STK 11, it should no longer be used. This command has been replaced by the CommSystem command.

The Comm CommSystem Interference command allows you to control the definition and use of interference in Comm system calculations.

Enter Yes to calculate interference; enter No if interference should not be calculated. If Yes is entered then you must specify the {PFDRefBandwidth}.

Valid values for {PFDRefBandwidth} are 1Hz, 4kHz, 40kHz, 1MHz, 10MHz, 20MHz, 40MHz.

Example

To include interference in Comm System calculations and set the PFDBandwidth to 40kHz:

Comm */CommSystem/CommSys1 CommSystem Interference Yes 40kHz

ReturnMessage

If activated, Connect returns an acknowledgement message.

Group Membership

This command belongs to the following group(s):

Comm

Deprecated Commands

Version

11

STK Programming Interface 11.0.1