Comm CommSystem Interval

Set the time interval to be used for computing a comm system (Deprecated Command)

Syntax

Comm <CommSysObjectPath> CommSystem Interval {UseScenarioTime} <StepSize> [{TimeInterval}]

ATTENTION: THIS COMMAND IS DEPRECATED and has been replaced by:

Description

Note: This command was deprecated in STK 11, it should no longer be used. This command has been replaced by the CommSystem command.

The Comm CommSystem Interval command allows you to set the time interval to be used for the Comm System.

{UseScenarioTime} can be Yes or No. If {UseScenarioTime} is No, you must specify {TimeInterval}.

<StepSize> should be entered in seconds.

For valid {TimeInterval} values see Time Options.

Example

To set the time interval for the CommSys1 so that it corresponds to the Start and Stop Times for the scenario and uses a step size of 60 seconds:

Comm */CommSystem/CommSys1 CommSystem Interval Yes 60

To specify a time interval for the CommSys1:

Comm */CommSystem/CommSys1 CommSystem Interval No 60 "Satellite/ShortSat EphemerisTimeSpan.Start Time Instant" "30 Aug 2011 20:30:00.00"

ReturnMessage

If activated, Connect returns an acknowledgement message.

Group Membership

This command belongs to the following group(s):

Comm

Deprecated Commands

Version

11

STK Programming Interface 11.0.1