Set RF system temperature properties for radars (Deprecated Command)
Radar <RdrObjectPath> SysTemp {SystemOptions} <Parameters>
Note: This command was deprecated in STK 10.1, it should no longer be used. This command has been replaced by the Radar command.
The Radar Connect commands were enhanced in STK 10.1 to make use of attributes and to simplify the format required to use these commands. For more information on using the new format see Transitioning to the New Radar Format.
The Radar SysTemp command allows you to set the system temperature properties for an RF antenna. {SystemOptions} can be:
| {SystemOption} | <Parameters> |
|---|---|
| Constant | <Temperature> |
| TransLineLoss | <LineLoss> in dB |
| TransLineTemp | <LineTemp> |
| NoiseFigure | <Value> in dB |
| AntNoise | {AntNoiseOption} <AntNoiseParams> |
| {AntNoiseOption} | <AntNoiseParams> |
|---|---|
| Constant | <Temperature> |
| External | "<FilePath>" |
| Calculated | {Earth | Sun | Atmosphere | Rain |
Cosmic | <Temperature>}
You can enter one or more of these values when {SystemOption} is AntNoise and {AntNoiseOption} is Calculated. |
All <Temperature> related values are set using the temperature units set at the scenario level.
To set the transmission line loss at -23 dB for the TestRadar:
Radar */Satellite/ERS1/Radar/TestRadar SysTemp TranslineLoss -23
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
10.1
STK Programming Interface 11.0.1