Specify SEET magnetic field graphics options.
SEET <ScenarioPath> Graphics MagField {GfxOptions}
The following table describes the options available for setting magnetic field graphics parameters.
| {GfxOptions} | Description |
|---|---|
| Show {On | Off} | Specify whether magnetic field graphics should be displayed. |
| ColorBy {Magnitude | Latitude} | Specify Magnitude to have colors assigned based upon the magnetic field strength; specify Latitude to have colors assigned based upon the latitude of the footprint of the field lines. |
| ColorScale {Linear | Log} | Specify Linear for colors assigned based upon a linear color ramp of the value; Specify Log (only available when coloring by magnitude) for colors assigned based upon a linear color ramp using the logarithm of the values. |
| ColorRampStart {Color} | Specify the ramp start color. For valid {Color} options see Common Options. |
| ColorRampStop {Color} | Specify the ramp stop color. For valid {Color} options see Common Options. |
| MaxTranslucency <Value> | Specify the maximum translucency. <Value> is a number between 0 and 100. |
| LineWidth <Width> | Indicate a pixel width value between 1.0 and 10.0 |
| Style {LineStyle} | For valid {LineStyle} options see Common Options. |
| FieldLineRefresh <Value> | Specify the number of seconds between times that the magnetic field will be recomputed. |
| NumFieldLines <Value> | Specify the number of field lines to draw per longitude. |
| NumLongitudes <Value> | Specify the number of longitudes to consider. |
| StartLat <Value> | Specify the latitude (in degrees) of the footprint of the first field line to draw. |
| StopLat <Value> | Specify the latitude (in degrees) of the footprint of the last field line to draw. |
| RefLongitude <Value> | Specify the first longitude to draw.
<Value> is specified in degrees.
Longitude is measured from the negative X-axis of the Solar Magnetic coordinate system. Thus, 180 deg corresponds to a magnetic local time of 12:00 noon, where this longitude lies on the lit side if the Earth-Sun line. |
| FieldLineMode {Dipole | FullField} | Specify the method for producing field lines. |
| MainField {CenteredDipole | FastIGRF | IGRF} | Specify the main field model for the geomagnetic field. |
| ExternalField {None | OlsonPfitzer} | Specify the external field model for the geomagnetic field. |
| IGRF_UpdateRate <Value> | Specify the number of seconds between times when the IGRF model will Recompute its time-dependent coefficients. |
To set graphics options for the Scenario:
SEET * Graphics MagField Show On ColorBy Magnitude LineWidth 5.0
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
9.1
STK Programming Interface 11.0.1