Set units of measure to be used when generating and displaying reports during the current Connect session (Deprecated Command)
SetConnectReportUnits <ScenarioPath> {Dimension} <Unit> ["<Offset>"] [{Dimension2} {Unit2}...]
Note: This command was deprecated in STK 10.1, it should no longer be used. This command has been replaced by the Units_Set command.
The SetConnectReportUnits command allows the user to set a special set of units to be used for reports and graphs generated via Connect. The units of measure available are identical to the units for the SetGUIUnits command. Units set by this command will not alter units used by reports generated via the GUI.
The units set by this command will only be used if the ConnectReportUnits Flag has been set to On using the SetConnectReportUnitsFlag command.
If Connect Report Units are being used, then units set for individual reports will be overridden, and the Connect report units will be used. This command is especially useful when reports are being displayed via the GUI (e.g. dynamic display reports) and you want the units on reports created via Connect to be different then the units used for the GUI reports.
Hint: Connect recognizes a number of <Unit> abbreviations. Use the abbreviated commands or alternative forms to set units. You can also change the units used to relay commands using the SetUnits command or the units used to input data via the user interface using the SetGUIUnits command.
To set Connect report units as follows: the time units to display in hours, the distance units to display in kilometers, the bandwidth to display in gigahertz, and the ratio to display in decibels:
SetConnectReportUnits * Time Hour Distance KM Bandwidth GHZ Ratio Decibel
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
10.1
STK Programming Interface 11.0.1