TE_Vector
Generate a vector for T&E.
Syntax
TE_Vector <ObjectPath> Add Name "<Name>" AnalysisObject "<Name>" Mapping "<Name>" PointPath "<Name>" <Parameters>
Related Commands
Description
The T&E Toolkit (v1.5) Plugin must be installed in order to use this command.
The TE_Vector command is used to create a vector using the vector mapping and attachment point specified.
Name "<Name>" specifies the name of the vector. This parameter is required.
AnalysisObject "<Name>" is the name of the analysis object. This parameter is required.
Mapping "<Name>" is the name of the vector mapping. This parameter is required.
PointPath "<Name>" is the name of the attachment point. This parameter is required.
The following table describes other parameters.
| <Parameters> | Description |
|---|---|
| Color "<Color>" | Enter a color for the vector. The default color is white.
Color may be entered using name, value or %rgb. |
| ShowLabel "{On | Off}" | The default value is Off. |
| ShowValue "{On | Off}" | The default value is Off. |
| Size "<Number>" | Specify the size of the vector, valid values are between 1 and 100.
This vector size will be used for all vectors in the scenario. |
| IntervalPath "<Point>" | Enter name of time interval vector. |
Example
TE_Vector * Add Name "Vector1" AnalysisObejct "AF385" Mapping "OwnshipVector" PointPath "Center" ShowLabel "ON" ShowValue "ON" Color "orange" Size "5.0" IntervalPath "Radar_Run1"
ReturnMessage
Group Membership
This command belongs to the following group(s):
Version
11.6