Set Particle Flux parameters.
SEET <VehiclePath> ParticleFlux {FluxOptions}
This command is valid for Satellite, Missile & Launch Vehicle.
| {FluxOptions} | Description |
|---|---|
| F10.7Source {StaticValue | UseFluxFile} | Specify the manner in which the F10.7 (flux solar measure) is obtained. |
| F10.7 <Value> | When F10.7Source is StaticValue, enter a <Value> between 0.0 and 250.0 for F10.7. |
| FluxFile "<Filepath>" | When F10.7Source is UseFluxFile, enter the name of the flux file. |
| Area <Value> | Enter the area exposed to particle impacts. <Value> should be between 0.01 and 100000 m^2. |
| PitDepth <Value> | Enter the depth (in mm) at which damage is considered to occur due to a penetrating particle. <Value> should be between 0.0 and 100.0 mm. |
| UseSporadicMeteors {On | Off} | Specify the use of sporadic meteors. |
| Material {MaterialType} | Enter the material exposed to particle
impacts.
Valid values for {MaterialType} are Aluminum, Copper, Iron, Silver, Platinum, Gold, BeryliumCopper, StainlessSteel, Titanium, Mylar, Glass, UserDefined |
| MaterialDensity <Value> | When Material is UserDefined, enter the density (in g/cm^3) of the material exposed to particle impacts. <Value> should be between 0.0 and 25.0 g/cm^3. |
| TensileStrength <Value> | When Material is UserDefined, enter the tensile strength of the material (in MPa). <Value> should be between 1.0e-6 and 4000.0 MPa. |
To set the vehicle particle flux parameters:
SEET */Satellite/Satellite1 ParticleFlux F10.7Source StaticValue F10.7 37.45
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
9.1
STK Programming Interface 11.0.1