Set a SEET constraint for a vehicle
SetConstraint <ObjectPath> {ConstraintName} <Parameters>
Warning: Caution should be exercised when turning a constraint Off, in that any previously set constraint values may be lost. These cannot be recovered when the constraint is subsequently turned On.
The SetConstraint command turns SEET constraints On and Off and also sets values for the constraints. The following table lists valid values for {ConstraintName} as well as the parameters accepted for each. Only one constraint can be set with each SetConstraint command.
The following constraints are valid for Satellite, LaunchVehicle and Missile:
| {ConstraintName} | Parameters |
|---|---|
| SEETSAAFluxIntensity | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in m^2*sec*steradian and are between 0.5*1.0e4 and 10000.0*1.0e4. |
| SEETDamageFlux | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0. |
| SEETDamageMassFlux | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0. |
| SEETImpactFlux | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0. |
| SEETImpactMassFlux | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in kg/sec/m^2 and are between 1.e-25 and 1.0. |
| SEETVehicleTemperature | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in degrees Kelvin and are between 0.0 and 5770. |
| SEETMagFieldLineSeparation | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are entered in degrees and are between 0.0 and 180.0. |
| SEETMagFieldLshell | {Off | Min <Value1> [|] Max <Value2>} [ExcludeIntervals | IncludeIntervals], where <Value1> and <Value2> are between 1.0 and 100.0. |
To set a minimum and maximum values for the SEETDamageFlux constraint:
SetConstraint */Satellite/Satellite1 SEETDamageFlux Min 0.0000001 Max 0.001
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
9.1
STK Programming Interface 11.0.1