VO SurfaceLines

Set lines in a 3D window to be drawn on terrain.

VO <ScenarioPath> SurfaceLines {LineOptions}

Use the VO SurfaceLines command to put surface lines on terrain. This is a scenario level setting that affects the following lines:

Area Targets
Line Targets
Range Contour rings - On facility and place, when Use terrain data is checked and on terrain following ground vehicles
Map Details
Lat/Lon Lines
Equator and Prime Meridian lines
VPF Data
Vehicles - Routes on terrain following ground vehicles; Ground tracks on non-ground vehicles and Swaths on non-ground vehicles

Valid values for {LineOptions} are described in this table.

{LineOptions}	Description
OnTerrain {On \| Off \| WhenTerrainServerIsOn}	If set to On and terrain is under the line, then the line will conform to the terrain. If set to WhenTerrainServerIsOn then the line will be shown when the visualization for a 3D window is using the terrain server. Note: For best performance only turn On when terrain is present.

To set lines to be drawn on terrain:

VO * SurfaceLines OnTerrain On

If activated, Connect returns an acknowledgement message.

This command belongs to the following group(s):

11.0

STK Programming Interface 11.0.1