Description | Example | Return message | Group

GetDspTimes

Return the display time data for an object

Syntax

GetDspTimes <ObjectPath> {DataOption}

Related commands

Description

Use the GetDspTimes commands to return information about the display times defined for facilities, places, targets, sensors, area targets or line targets. Also, antennas, receivers, or transmitters.

The following table describes the {DataOption}.

{DataOption}Description
StateReturns information about the status of the display times for the specified object
IntervalsReturns information about the display interval pairs set for the specified object. This includes any access interval pairs that may be valid.

If you choose the State {DataOption}, Connect returns a message that identifies the display state of the specified object. The return message specifies the display state for the object as either AlwaysOn, AlwaysOff, Interval or Access.

Examples

To find out the time periods during which the Landover Facility will be displayed in the 2D Graphics window:

GetDSPTimes */Facility/Landover Intervals

To find out the time periods during which Antenna1 will be displayed in the 2D Graphics window:

GetDspTimes */Place/Place1/Antenna/Antenna1 Intervals

Return message

Connect returns a message that contains the current display intervals set for the object.
ACK
GETDSPTIMES 103
1 Jun 2000 01:00:00.00" "1 Jun 2000 06:00:00.00", "1 Jun 2000 11:00:00.00" "1 Jun 2000 16:00:00.00"

Group membership

This command belongs to the following group(s):

Area Targets

Comm

Facilities, Places & Targets

Line Targets

Sensors

Version

11.5