Set generic contour options for a receiver, transmitter, radar or antenna
Graphics <ObjectPath> Contours {ContourType} {ShowGfxState} {RelMaxState}
Use the Graphics Contours command to set generic contour options for a receiver, transmitter, radar or antenna.
For Receivers and Antennas the only valid value for {ContourType} is Gain.
For Transmitters and Radar valid values for {ContourType} are Gain, EIRP, FluxDensity or RIP.
For {ShowGfxState} and {RelMaxState}, valid values are On or Off. If {RelMaxState} is set to On, then contour level values are assumed to be relative to the maximum value.
Hint: Once you've set the {ContourType} and its associated parameters, use the Graphics Levels (Comm & Radar) command to set the contour levels to display on the Map.
To set the graphics properties of the GndRcvr receiver so that gain contour graphics appear, the relative to maximum flag is Off:
Graphics */Facility/Customer/Receiver/GndRcvr Contours Gain On Off
If activated, Connect returns an acknowledgement message.
This command belongs to the following group(s):
7.1
STK Programming Interface 11.0.1